02-04-2016, 05:28
Hi Mark
Yes, it should blink as it receives data, what seems that is not happening, which causes the RED warning to appear on the display.
So, or there are a problem in the TX module on the RX unit, or a problem on the RX module on the WD unit, I can't see any other reason.
I suppose you have installed an antenna on the TX output of the receiver unit.
Do you have the RX unit powered via the external power supply (12V)?
Edited: I wrote this post before you added the pictures. So for now seems we can eliminate the problem with the TX module on the RX unit
(02-04-2016, 04:23)Wizza Wrote: What should the LED do on a working WirelessDisplay..??? Should it blink as it receives data..???
Yes, it should blink as it receives data, what seems that is not happening, which causes the RED warning to appear on the display.
So, or there are a problem in the TX module on the RX unit, or a problem on the RX module on the WD unit, I can't see any other reason.
I suppose you have installed an antenna on the TX output of the receiver unit.
Do you have the RX unit powered via the external power supply (12V)?
Edited: I wrote this post before you added the pictures. So for now seems we can eliminate the problem with the TX module on the RX unit