[Sun_Dancer]

Hi Sun_Dancer,

I must say that here is a highly creative work...
I suppose you printed it in ASA or PETG to be resistant to UV.
How you dealt with doing with waterproof?

Rgs
Werk_AG

Hello Werk_AG,

Sometimes I'm just a playful little boy

I printed the lower part with ASA filament, the upper part with PETG. ASA filament is a bit stubborn, it warps up very quickly and the upper half just wouldn't work, so it was printed with PETG. I sealed both parts with a sticky sealant, hot glue and at the end with a lot of primer and spray paint. After several days of rain and snow, I can say that the housing is tight.

greetings