This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wireless Display Fahrenheit off
#11
Hi danner,

Please download the software package again, version number issue is now fixed.
Thank you
MeteoCercal - Air Quality Data
Click here to watch at my ThingSpeak channel



Reply
#12
Thanks, the proper version is now displayed, however, the inside temperature is still incorrect.
Reply
#13
Are you using a local sensor, of receiving inside temperature from the main unit (WeatherDuino receiver)?

Edited: Sorry, I already have the answer from your PM.
MeteoCercal - Air Quality Data
Click here to watch at my ThingSpeak channel



Reply
#14
This is the sequence as it starts up. The actual temperature in my room is 67.6F.

[Image: thrXuaX.jpg]

[Image: A5y64Ek.jpg]

[Image: yXzaRzQ.jpg]

[Image: nCMnk10.jpg]
Reply
#15
Not sure if this helps or not, but if I do not select the local temp sensor on the WD and instead tell it to use the indoor temp sensor from the Pro2+ receiver, then the displayed inside temperature is correct. Of course the temp is from the other room where the Pro2+ receiver is, but it is the correct temperature. When I change it back to use the local temp sensor, which is the first SHT35-D I ordered that came configured as 0x45, then the inside temp reads about 29F cooler than it should.
Reply
#16
It appears that the WD update from WeatherDuino Pro2 PLUS WD v3.0_b008 now shows the correct local temperature at the WD.

I did notice, however, that the "Receiver Location T/H" on the System Info screen the temp and humidity read 0.0F 0.0%

Thanks for the fix for the main screen! Please don't worry about the System Info screen until you're settled.
Reply
#17
(09-09-2017, 09:43)danner Wrote: ...
I did notice, however, that the "Receiver Location T/H" on the System Info screen the temp and humidity read 0.0F 0.0%

Fixed in WeatherDuino Pro2 PLUS WD v3.0_b009
Thanks for your help
MeteoCercal - Air Quality Data
Click here to watch at my ThingSpeak channel



Reply
#18
Fixed, thanks! :-)
Reply




Users browsing this thread: 1 Guest(s)