Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

AQM3 Initial Setup
#6

Hi Wx_man23,

I would recommend you to use soldered screw terminals on the PCB, e.g. type KF128-2.54. It will be much easier for you to experiment with them and they can also serve well for a permanent connection (they are more reliable than just push-in pins).

   

It can then look like this - but be careful! The picture shows my old AQM, the connector for your PMS7003 is probably located elsewhere on your "new" board.

   

Good luck!

Best Regards
Zdenek

[Image: banner.php]
My outdoor AQM-I: here
Reply


Messages In This Thread
AQM3 Initial Setup - by Wx_man23 - 14-05-2024, 01:06
RE: AQM3 Initial Setup - by werk_ag - 15-05-2024, 23:30
RE: AQM3 Initial Setup - by Wx_man23 - 16-05-2024, 21:43
RE: AQM3 Initial Setup - by werk_ag - 17-05-2024, 18:19
RE: AQM3 Initial Setup - by Wx_man23 - 17-05-2024, 22:55
RE: AQM3 Initial Setup - by werk_ag - 29-05-2024, 01:41
RE: AQM3 Initial Setup - by hornychz - 22-05-2024, 23:18



Users browsing this thread: 1 Guest(s)