1. WeatherDuino Forum
  2. Weather Equipment - General Discussion
  3. Weather Equipment
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
AQM III indoor Case for SPS30 and PMS7003
Sun_Dancer
WeatherDuino 4Pro User
*****
Posts: 51
Threads: 18
Joined: Jul 2019
Weather Station: ILEIPZ27
Country: Germany
#1

18-09-2021, 04:11
(This post was last modified: 26-09-2021, 20:58 by Sun_Dancer.)
Hello weather frogs!

This is a 2-part indoor housing for the WeatherDuino Air Quality Monitor III with Sensorion SPS30 or Plantower PMS7003 for particle measurement, MH-Z19 for Co2 measurement and 1.3 inch OLED.
The AQM board is attached between the two halves of the housing with 4 M3x10 screws.

You can find the case for the Sensirion Sensor and further information on my Thingiverse profile

https://www.thingiverse.com/thing:4967779

you can find the Plantower version here:
https://www.thingiverse.com/thing:4974448

If you like it, please leave a like, thanks.


Attached Files Image(s)
           
pWS_Sun_Dancer  WeatherDuino 4Pro+ Millenium Falcon; WeatherDuino Stuff at Thingiverse
 
Find
Reply
uncle_bob
Development Team
*****
Posts: 870
Threads: 31
Joined: Jul 2014
Weather Station: Conder Weather, Canberra
Country: Australia
#2

18-09-2021, 12:51
Nice work mate.

(18-09-2021, 04:11)Sun_Dancer Wrote:  Hello weather frogs!

This is a 2-part indoor housing for the WeatherDuino Air Quality Monitor III with Sensorion SPS30 for particle measurement, MH-Z19 for Co2 measurement and 1.3 inch OLED.
The AQM board is attached between the two halves of the housing with 4 M3x10 screws.

You can find the case and further information on my Thingiverse profile

https://www.thingiverse.com/thing:4967779

If you like it, please leave a like, thanks.
Conder, Canberra Weather

Find
Reply
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
  1. WeatherDuino Forum
  2. Weather Equipment - General Discussion
  3. Weather Equipment