WeatherDuino Forum

Hello weather frogs!

This is a 2-part indoor housing for the WeatherDuino Air Quality Monitor III with Sensorion SPS30 or Plantower PMS7003 for particle measurement, MH-Z19 for Co2 measurement and 1.3 inch OLED.
The AQM board is attached between the two halves of the housing with 4 M3x10 screws.

You can find the case for the Sensirion Sensor and further information on my Thingiverse profile

https://www.thingiverse.com/thing:4967779

you can find the Plantower version here:
https://www.thingiverse.com/thing:4974448

If you like it, please leave a like, thanks.

Nice work mate.

(18-09-2021, 04:11)Sun_Dancer Wrote: [ -> ]Hello weather frogs!

This is a 2-part indoor housing for the WeatherDuino Air Quality Monitor III with Sensorion SPS30 for particle measurement, MH-Z19 for Co2 measurement and 1.3 inch OLED.
The AQM board is attached between the two halves of the housing with 4 M3x10 screws.

You can find the case and further information on my Thingiverse profile

https://www.thingiverse.com/thing:4967779

If you like it, please leave a like, thanks.