09-07-2019, 23:44
(09-07-2019, 18:45)daveh Wrote: Thank you. I did the factory reset and it is now working normally again. I will keep a close watch on it for a while. Have you any idea why the two counts would go out of sync? Is it something I could have done?
Software versions.
P2AT328_RX_v4.0_b001
Pro2_Universal_TX_v6.0_b007
P2AT328_WD_v6.0_b002
A change of the Arduino Nano on the TX unit without a factory reset on the receiver is the most frequent cause of this issue.
The software versions you are using were are from a software package released on 2018-03-27. The latest software package for the Pro2 system is dated of 2019-04-13.
If possible, try to upgrade the software of your units to latest release.
Important: First upgrade the TX unit, then the RX. After upgrade, and before connecting Cumulus, do a Factory Reset on the RX.
Rgs