[uncle_bob]

I the changed up the default bed back a month or two back, with a ultrabase knock off. Sometimes it sticks well, then sometimes it doesn't. Normally putting down glue on it works. Getting the bed level on four points is now impossible. You get one corner good, then the other corner goes out. The youtuber "The First Layer" and few other second opinions say to just level on 3points, seems to work better.

Anyway, 3D printing has been interesting ongoing journey, assembling, modding, marlin firmware, octopi (a must for any USB and SD host printer).
Next weekend I'll print the outer case again using some glue and maybe a brim.
Cheers for the great design! It's very good!