25-03-2018, 08:03
Hi Werk, I am not sure if this is related or not. I updated my Tx to v6.0_b004 today and ran into a no transmission problem. I replicated this on two separate Tx boards, my master being version 2.50 and my secondary board which is not in use, version 3.12. I tried two different Nanos with the same result.
It was when I configured the second board with no temperature sensors in use I found a clue, because then the latest software version started transmitting.
I use an SHT1x sensor, and it is whenever I have sensor 1 activated for use with the SHT1x (option 0) that my Tx boards fail to transmit at all. I have sensor 0 disabled.
I do not know if anyone else still uses the SHT1x sensor, or perhaps f4aii does use one and not a DHT22? The previous V6.0 software was no problem with this sensor, and is what I have reverted to for now. I have updated the Rx to the latest and all seems well there.
I hope I have not misunderstood the upgrade somewhere
It was when I configured the second board with no temperature sensors in use I found a clue, because then the latest software version started transmitting.
I use an SHT1x sensor, and it is whenever I have sensor 1 activated for use with the SHT1x (option 0) that my Tx boards fail to transmit at all. I have sensor 0 disabled.
I do not know if anyone else still uses the SHT1x sensor, or perhaps f4aii does use one and not a DHT22? The previous V6.0 software was no problem with this sensor, and is what I have reverted to for now. I have updated the Rx to the latest and all seems well there.
I hope I have not misunderstood the upgrade somewhere