25-01-2015, 02:54
(25-01-2015, 00:31)uncle_bob Wrote: It's amazing there may soon be more users of this system down here than in Europe
Be careful, UK is on the run! Some cards are now flying there!
Even more amazing is that there are more users only in Australia than in my own country!
(25-01-2015, 02:30)qldbureau Wrote: It was a Whirlpool post with the link I noticed yesterday, which turned out to be a very good referral! I am handy with a soldering iron and kit construction so I should be pretty good with that. As far as the software side of things, could be a bit more of a challenge if I run into issues. Anyway I am familiar with the IDE and uploading into an Arduino so I should have a start!
Welcome to this growing community.
You will build it in a breeze! The software is very simple to configure, just check, or if needed change some values clearly identified near the first lines of the code, compile and upload to the Arduino.
And for any doubt, we are here. As uncle_bod said, just sing out!