25-03-2018, 09:39
WeatherDuino Pro2 Universal TX v6.0_b004
I removed from TX: #define TH_SENSOR_1 0 // DHT22
the TX transmits the frames again, I will wait for the next patch to be able to reactivate the DHT22
WeatherDuino Pro2 PLUS AT2560 RX v6.0 b010
On the RX, when I'm on the system info, the clock is displayed 20 seconds later, when I press on the screen to display the system info again, I come back to the home screen instead to return to the screen where I was
#define BACKLIGHT_TIMEOUT 0 // Timeout for display backlight in minutes (1 to 255). 0 = Always ON
#define USE_BIGCLOCK 1 // Instead of turning off TFT backlight, show a big clock screen. 0 = No, 1 = Yes
I do not want to see the clock, I indicated in the config but on the home screen, the clock is always displayed after 60 seconds.
Nothing really annoying.
Convenient access to different menus
thank you
No problem with WD.
I removed from TX: #define TH_SENSOR_1 0 // DHT22
the TX transmits the frames again, I will wait for the next patch to be able to reactivate the DHT22
WeatherDuino Pro2 PLUS AT2560 RX v6.0 b010
On the RX, when I'm on the system info, the clock is displayed 20 seconds later, when I press on the screen to display the system info again, I come back to the home screen instead to return to the screen where I was
#define BACKLIGHT_TIMEOUT 0 // Timeout for display backlight in minutes (1 to 255). 0 = Always ON
#define USE_BIGCLOCK 1 // Instead of turning off TFT backlight, show a big clock screen. 0 = No, 1 = Yes
I do not want to see the clock, I indicated in the config but on the home screen, the clock is always displayed after 60 seconds.
Nothing really annoying.
Convenient access to different menus
thank you
No problem with WD.