10-02-2018, 22:54
(10-02-2018, 21:24)Barrow4491 Wrote:Hi,(10-02-2018, 08:33)Barrow4491 Wrote:(10-02-2018, 05:31)dormani Wrote: I am having a similar experience using AQ software 7.0 b007. I started experiencing this when I moved the monitor outside and placed under our pergola. It has been extremely hot here over the last month so I am wondering if this may be the cause. The pergola is partially enclosed and runs a couple of degrees hotter than outside.
Regards
Ian
It is now happening every time I boot the AQ monitor, so i changed the sensor and it gives the same response on the serial monitor shown below. I find it difficult to believe I have two faulty sensors bought some months apart.
Regards
Jim
Code:WeatherDuino 4Pro
Air Quality Monitor v7.10 b003
Please wait...
Waking up the PMS7003 dust sensor (40s)
Reading PMS7003 dust sensor...
PMS7003 readings:
PM2.5: 0.00 ug/m3
PM10 : 0.00 ug/m3
PM2.5_1H_Avg : nan
PM2.5_NowCast: nan
I re downloaded the software from the website and all is now good. My laptop which I usually use for WeatherDuino is in for repair and I have been using my desktop in the meantime.
Maybe that had something to do with it
Jim