01-01-2018, 21:33
That version is very fine.
Please check on the Cumulus.ini file if the defined COM port is the same detected by the Device Manager for your Meduino board (Arduino Mega 2560). Also check the station type (should be type 1). There are also other Cumulus settings that you should check, but firtly lets try to make Cumulus communicate with your weather station.
What happens when you try to start Cumulus? If your RX board reinitialize alone when you try to start Cumulus, please change position of the Prog/ Run switch.
Please check on the Cumulus.ini file if the defined COM port is the same detected by the Device Manager for your Meduino board (Arduino Mega 2560). Also check the station type (should be type 1). There are also other Cumulus settings that you should check, but firtly lets try to make Cumulus communicate with your weather station.
What happens when you try to start Cumulus? If your RX board reinitialize alone when you try to start Cumulus, please change position of the Prog/ Run switch.