01-01-2018, 08:27
(31-12-2017, 21:28)cjthomson Wrote: ... I think it's the component that sits between the USB port and the end of the CH340 controller.
Yes, its that component (black with white trace in one of the sides).
Before the radical step of removing the Nano from a Pro2 v6 board, may I sugest that you try to running the system with exactly the same version of CumulusMX but running on a PC, just to check if the USB connection will break.
Is the PI3 executing any other tasks than running CumulusMX?
You may also try to add this parameter to your Cumulus.ini file in the Station section:
Code:
VP2SleepInterval=1500