23-10-2017, 04:05
Indeed, those high gusts seem strange, but I don't know what to say... As you can easily check, the routines used to measure the wind gusts are the same since long time, both in the RX and the TX software.
I think you are referring to the VP2_WindRes setting in the RX software, right?
Perhaps you know about it, anyway unless you really want to have a resolution on just 1mhp (1.6Km/h), you can use any of the other wind resolution options with your Davis anemometer.
Gives a good balance between resolution and max. wing gust reading (~182 Km/h)
What I wrote above don't solve any possible issue with wind gust spikes, its just an info.
(22-10-2017, 12:42)markkkk42 Wrote: I am using a davis sensor pack and the setting in the software is 0 for the davis
I think you are referring to the VP2_WindRes setting in the RX software, right?
Perhaps you know about it, anyway unless you really want to have a resolution on just 1mhp (1.6Km/h), you can use any of the other wind resolution options with your Davis anemometer.
Code:
#define VP2_WindRes 2What I wrote above don't solve any possible issue with wind gust spikes, its just an info.