[hornychz]

Hornychz: What have you used to make such neat cylindrical holes in your shield plates, and spacers to separate them. Where did you get the little case? I love the method and is what I will likely use. I have homemade my temp/humidity shield using flower pot saucers and PVC drain pipe through the center, where the sensor is installed with fan on the bottom.  It does the job very well, though probably not very attractive. I plan to rebuild using a stiffer saucer plastic.

Sorry qldbureau I have not answered yet. The Akismet system has identified my response as spam, and this situation is still being addressed.