25-07-2017, 21:18
(25-07-2017, 20:34)danner Wrote: OK thanks.
I would rather all the modules be the same address in case the SHT35 fails then I can simply swap it out for the SHT31. How do I change the address on the ClosedCube module?
This is from Tindie who sells the ClosedCube SHT35:
•I2C address (7-bit) can be 0x44 or 0x45 (pre-set)
Its nice having the possibility to choose the address, but its a pity that they don't supply the sensor with the most common address which is 0x44 set by default.
(25-07-2017, 20:41)danner Wrote: Oh you have to be kidding me. Have to move a surface mount resistor to change i2c addresses? LOL. Nope, that's not going to happen.
Is not as hard as it seems. Its only a 0 Ohm resistor or in other terms, a shunt.