02-07-2017, 16:33
Hi Everyone
I hope you might be able to help me. I've finally gotten round to finishing off and testing my WeatherDuino TX Board (v3.12) and it seems that it is not transmitting at all. The TX LED light's up every few seconds as expected but my RX unit does not detect any signal from it. My RX unit has for the last 12 months been setup to receive data from my Auriol sensors so I know that it's receiver is absolutely fine.
I have tried using my USB RTL SDR dongle and Gqrx software for scanning the RF signals and do not see any transmissions that match moments that the TX LED flashes. I'm only every seeing the transmissions coming from my existing Auriol sensors.
I have limited experience in electronics and wondered if you can give me some pointers as to what to test.
In the TX configuration file I've enabled the debug options and can see that the board is reading from my Davis Wind Vane/Speed sensor and the SHT-31 temperature sensor.
Any advice would be gratefully received.
Regards
Chris
I hope you might be able to help me. I've finally gotten round to finishing off and testing my WeatherDuino TX Board (v3.12) and it seems that it is not transmitting at all. The TX LED light's up every few seconds as expected but my RX unit does not detect any signal from it. My RX unit has for the last 12 months been setup to receive data from my Auriol sensors so I know that it's receiver is absolutely fine.
I have tried using my USB RTL SDR dongle and Gqrx software for scanning the RF signals and do not see any transmissions that match moments that the TX LED flashes. I'm only every seeing the transmissions coming from my existing Auriol sensors.
I have limited experience in electronics and wondered if you can give me some pointers as to what to test.
In the TX configuration file I've enabled the debug options and can see that the board is reading from my Davis Wind Vane/Speed sensor and the SHT-31 temperature sensor.
Any advice would be gratefully received.
Regards
Chris