Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New Build
#9

(12-06-2017, 12:10)Derek Wrote:  I was concerned that the sensor (sht21)would not work on my cable, which is just over 2 mtrs long.
In fact it works fine.
I wired up my SHT31 to a 2m/6ft CAT5E cable plugged into the EI2C port just to see if it would work, and so far it seems to be operating OK.
Reply


Messages In This Thread
New Build - by Derek - 11-06-2017, 16:30
RE: New Build - by hornychz - 11-06-2017, 17:17
RE: New Build - by uncle_bob - 12-06-2017, 00:04
RE: New Build - by Derek - 12-06-2017, 12:10
RE: New Build - by werk_ag - 12-06-2017, 16:07
RE: New Build - by werk_ag - 12-06-2017, 00:34
RE: New Build - by danner - 12-06-2017, 07:47
RE: New Build - by zitoune - 12-06-2017, 08:42
RE: New Build - by danner - 12-06-2017, 21:50
RE: New Build - by clubjoker - 14-06-2017, 15:13
RE: New Build - by werk_ag - 15-06-2017, 19:24
RE: New Build - by danner - 15-06-2017, 19:55
RE: New Build - by spudstrawb - 16-06-2017, 00:08
RE: New Build - by uncle_bob - 16-06-2017, 01:46



Users browsing this thread: 1 Guest(s)