03-06-2017, 02:36
(02-06-2017, 23:30)danner Wrote: ... but I am getting closer! :-)
It looks good! Soon all the leds will be blinking...
Don't worry too much about how to connect the SHT31. With a so short cable (3ft) it will work with any of the I2C ports on the board, but as you have installed the 82B715 chip, connect the sensor to the EI2C port.
Just avoid using the SCL and SDA signals on the same twisted pair of the cable. Twisting the SCL with VCC and SDA with GND gives the same result than twisting SCL with GND and SDA with VCC.
Regards