[AllanG]

Barrow4491 wrote:

Allan,
Thanks for that; I must have looked at that many times and did not see it
Jim
Enabled the internet , saved and reloaded the sketch but still no green light re the NTP server ( I assume it communicates with the NTP server via WiFi.) I don't expect any thing from the WU light as it is still disabled in the software.
I am starting to think the wifi module may be faulty??

Sometimes the most obvious is the last place we look; I know because I do it all the time...

I would be very surprised if the wifi module was faulty. How long have you left the PLUS board running without NPT connecting?? In my case, for some reason perhaps related to my router and network settings, it can be 10-20 minutes after power-on before I notice the green light has appeared while other times it's pretty well immediate. Can you see a connection in your router stats? Is there a router setting that may be preventing connection?? Is the timeserver you're connecting to online and available?? Just a couple of immediate suggestions, though I'm far from a networking expert!!

Allan.