28-01-2017, 07:40
(28-01-2017, 02:24)Werk_AG Wrote:
You never talked about your intention to have the two units working side by side ...
You never asked ... (I'm just joking).

Werk_AG
So, and for everyone which wants to have a Wireless Display unit working very close or side by side with a Pro2 receiver, here is a small and easy trick:
I might give it a try. There is always merit in simplicity. So I connect Pin 2 of the TX unit on the RX board (that's the 3rd pin from the 9V socket end of the TX unit?) to Pin 2 of the RX unit on the WD board (that's the one labelled "Dat" - the 2nd one from the top of the board?). See sketch attached/below for my understanding.
https://www.dropbox.com/s/5sz9it9ox8wtmq...s.jpg?dl=0
You say "don't use the GND pin of the TX module" for the common GND. So is the arrangement shown in the sketch in green okay?

