[Barrow4491]

I had it running for some hours yesterday but the ATM line on the WD remained a blank

Hi Jim,

Could you please tell me what ATM Display Unit have you set in RX_Config?
If you are using inHg temporarily change to mBar and check what happens.
There isn't any report of a bug with the ATM display on the WD units, but sometimes they appear.

#define ATM_Display_Unit 0 // 0 for mBar, 1 for inHg

Thanks

Werk,

I was using mBar but changed it to inHg and recompiled; it changed the Rx display as expected but still no data on the WD. I am at a loss!! The sensor is obviously working as the value is slowly dropping.

Another issue; when i looked at the WD config file i found that I had it set to use local TH sensor (1) and it is currently is not connected. Changed it to (0) and recompiled and loaded but no difference. this seems strange as the WD displays the Rx TH sensor values regardless of setting.

Thanks
JIm