01-09-2016, 23:54
(This post was last modified: 01-09-2016, 23:59 by Barrow4491.)
(01-09-2016, 23:00)Werk_AG Wrote:(01-09-2016, 07:39)Barrow4491 Wrote: ...
I have a couple of issues with the WD;
I am not getting Atmospheric pressure relayed
ATM is sent to the WD units once per minute, please wait some minutes and you should get it. The same for the clock info, you should wait 10 to 15 min for it to sync with the clock of your RX unit.
(01-09-2016, 07:39)Barrow4491 Wrote: It all looks reasonable except for solar radiation (1254 Wm2) and UV Index (17.1). Don't know where that is coming from as the sensors are enabled in software but not present yet.
Until you have the sensors installed, keep them disabled on the software.
Werk,
I had it running for some hours yesterday but the ATM line on the WD remained a blank
I will try again today and start them in sequence in case that is the issue.
I thought that the absence of the sensors may be causing the random data display but wanted confirmation
Regards
Jim