01-09-2016, 10:12
(01-09-2016, 07:39)Barrow4491 Wrote: Hi,
I am progressing slowly with my system and am currently testing my Receiver and Wd unit,
Congratulations for the job already done!
Quote:It all looks reasonable except for solar radiation (1254 Wm2) and UV Index (17.1). Don't know where that is coming from as the sensors are enabled in software but not present yet.
Yes indeed it's normal - as long as those sensor are not there you will get funny reading due to the voltage present at the arduino entry.
Quote:I have a couple of issues with the WD;
I am not getting Atmospheric pressure relayed
You read it correctly on the RX?
Quote:The Tx info screen shows two TX units 0 and 1 but I only have Unit 0 at present. Can I stop the TX1 info from displaying?
This is expected: you will see a series of zeros under the TX1 area if you have only one emitting.
Quote:I will post some photos with a bit of information re the construction in the next few days.
Looking forward to it!
Regards,
Zitoune[/quote]