01-09-2016, 07:39
Hi,
I am progressing slowly with my system and am currently testing my Receiver and Wd unit,
I am getting readings of wind, rain, (inside temp and RH as the outside sensors not in place yet), and on the receiver Atmospheric pressure.
It all looks reasonable except for solar radiation (1254 Wm2) and UV Index (17.1). Don't know where that is coming from as the sensors are enabled in software but not present yet.
I have a couple of issues with the WD;
I am not getting Atmospheric pressure relayed
The Tx info screen shows two TX units 0 and 1 but I only have Unit 0 at present. Can I stop the TX1 info from displaying?
I will post some photos with a bit of information re the construction in the next few days.
Thanks
Jim
I am progressing slowly with my system and am currently testing my Receiver and Wd unit,
I am getting readings of wind, rain, (inside temp and RH as the outside sensors not in place yet), and on the receiver Atmospheric pressure.
It all looks reasonable except for solar radiation (1254 Wm2) and UV Index (17.1). Don't know where that is coming from as the sensors are enabled in software but not present yet.
I have a couple of issues with the WD;
I am not getting Atmospheric pressure relayed
The Tx info screen shows two TX units 0 and 1 but I only have Unit 0 at present. Can I stop the TX1 info from displaying?
I will post some photos with a bit of information re the construction in the next few days.
Thanks
Jim