11-10-2014, 00:06
(10-10-2014, 18:22)loriz71 Wrote: ... A couple of questions. The variable resistor is used just 15k?
On the TX board, the R8 variable resistor must be adjusted to 10K as close as you can.
Quote:If I do not use the fan can live without it?
The fan is not required. You may build your Radition Shield without it.
Quote: To test it out I can connect the TX only with usb?
For testing, yes you can!
On the TX software, find this line: //#define Local_TestMode
and uncomment it.
Compile and upload.
Open Arduino IDE serial monitor. Almost every 3 seconds you will see a line of data. This data follow the easyweather.dat format.
There is an easier way to view the data sent by the USB port:
Install the Easyweather_RS232_Logger (freeware)
Download it from here: http://www.meteoestarreja.info/logger.php/