Didcot Instruments Weather Station. I have acquired some of the bits for this station See attached, Would it be reasonable to fit an Op Amp to the DRS-5 to get the signal up so that Weatherduino could read it. My knowledge of electronics is a bit limited.
Other bits I have acquired:
Anemometer DWR-205
Wind Vane DWD-205
Global Radiometer DRS-5
Net Radiometer DRN-301
Wet and dry PT100 thermometers DTS-5
DRS-5:
Silicon pV cell below polycarbonate diffuser, cosine corrected (see calibration Certificate) attached;
350-1100nm
14mV/kW/m2
Not sure how much of this can be made to work with Weatherduino.
The Wind vane and anemometer are easy the other bits less so; or maybe impossible.
Other bits I have acquired:
Anemometer DWR-205
Wind Vane DWD-205
Global Radiometer DRS-5
Net Radiometer DRN-301
Wet and dry PT100 thermometers DTS-5
DRS-5:
Silicon pV cell below polycarbonate diffuser, cosine corrected (see calibration Certificate) attached;
350-1100nm
14mV/kW/m2
Not sure how much of this can be made to work with Weatherduino.
The Wind vane and anemometer are easy the other bits less so; or maybe impossible.