[water01]

When putting in Lat and Long it says use tenth degrees so I assume that means mine should be

Code:

#define LATITUDE      511434        // Put here your Station latitude in tenths of degrees North
#define LONGITUDE     023149        // Put here your Station longitude in tenths of degrees East

although I am West of the Meridian so the second one may be wrong.

---

Hi water01

In your setup, you plan to use one RX unit and two TX units (just like mine )

Set the same Station ID for all the units.
Set one of yours TX unit as Unit ID = 0 and the other as Unit ID =1

Thanks Werk_AG.