11-10-2015, 23:59
(11-10-2015, 12:13)hoopstar Wrote: Long time reader, first time poster..
Firstly, awesome project.. I have a La Crosse weather station which the TX died in. I've been looking at running an Arduino based setup to interface with the wind/rain sensors and this looks to be right up my alley..
Anyway, just wondering if the schematics available for the WD Pro2 TX, RX and display units available...? I like a large amount of the system but have some 'tweaks' I'd like to run in my own setup.
Keep up the awesome work..
Hi, hoopstar
Hope you understand, but the schematics (not the eagle files) are available to system builders, only.
Anyway, with a careful look through the code it's possible to deduce the pins where most of the sensors and other devices are connected.
(11-10-2015, 22:25)uncle_bob Wrote: Hi Hoopstar,
You can find all the schematics here:
http://www.meteocercal.info/forum/forum-31.html
Only builders have access to that part of the forum. Remember?
