[hoopstar]

Long time reader, first time poster..

Firstly, awesome project.. I have a La Crosse weather station which the TX died in. I've been looking at running an Arduino based setup to interface with the wind/rain sensors and this looks to be right up my alley..

Anyway, just wondering if the schematics available for the WD Pro2 TX, RX and display units available...? I like a large amount of the system but have some 'tweaks' I'd like to run in my own setup.

Keep up the awesome work..

[uncle_bob]

Hi Hoopstar,
You can find all the schematics here:
http://www.meteocercal.info/forum/forum-31.html

[werk_ag]

Long time reader, first time poster..

Firstly, awesome project.. I have a La Crosse weather station which the TX died in. I've been looking at running an Arduino based setup to interface with the wind/rain sensors and this looks to be right up my alley..

Anyway, just wondering if the schematics available for the WD Pro2 TX, RX and display units available...? I like a large amount of the system but have some 'tweaks' I'd like to run in my own setup.

Keep up the awesome work..

Hi, hoopstar
Hope you understand, but the schematics (not the eagle files) are available to system builders, only.
Anyway, with a careful look through the code it's possible to deduce the pins where most of the sensors and other devices are connected.

Hi Hoopstar,
You can find all the schematics here:
http://www.meteocercal.info/forum/forum-31.html

Only builders have access to that part of the forum. Remember?

[uncle_bob]

Only builders have access to that part of the forum. Remember?

Apparently not

[hoopstar]

Hi, hoopstar
Hope you understand, but the schematics (not the eagle files) are available to system builders, only.

Totally understandable.

I assumed (dangerous I know) that given the Arduino base it was more open source than that.

Honestly I wasn't looking at ripping anything off but rather just interested to have a look at how you'd done a few things (ie. Fine offset input conditioning for one) compared to what I've been working on for my own system the past few months..

Anyway, I dug through my Silicon Chip magazines and found the articles that had what I was looking for.

Cheers

[werk_ag]

Anyway, I dug through my Silicon Chip magazines and found the articles that had what I was looking for.

So, as you can see, they are not a classified secret
Any question, please ask, I will try to help.

Cheers

[laulau]

Are the drawings accessible only after I have purchased the pcb?
Laurent

[Luboš]

Hi,

I would like to add to your community, but not found the forum no schematics for building WeatherDuino Pro2.

Can you please send instructions to offer the already assembled boards.

Thank you for your answer.

Best regarts

Luboš

[werk_ag]

Hi,

I would like to add to your community, but not found the forum no schematics for building WeatherDuino Pro2.

Can you please send instructions to offer the already assembled boards.

Thank you for your answer.

Best regarts

Luboš

Hi Luboš, Welcome

Regarding the schematics you have the answer some topics above, more precisely here:
http://www.meteocercal.info/forum/Thread...90#pid2890

The only board that can be supplied fully assembled is the RX v6.xx board, all others should be assembled by the end user.
About available boards and options, please check this topic:
http://www.meteocercal.info/forum/Thread...ailability

Thank you
Regards
Werk_AG

[Luboš]

Hi,
how can I become a builder with access to schematics WD Pro2.

Thanks.