26-08-2014, 11:28
Just a couple of things to note by the way.
In the Arduino IDE software,
You open the file named like this "WeatherDuino_RX_vxxx_bxxx.ino
and also set the software to the board type under tools/board/Arduino Nano w/ mega328
Edit: and the right Com port (as seen in the device manager of your computer).
In the Arduino IDE software,
You open the file named like this "WeatherDuino_RX_vxxx_bxxx.ino
and also set the software to the board type under tools/board/Arduino Nano w/ mega328
Edit: and the right Com port (as seen in the device manager of your computer).