08-09-2015, 01:25
Hi,
I have been checking my TX board with local test mode and I am getting readings. but with the new software tx v1.5 I am not getting a reading off the windvane, which is fine offset type.
so I then checked the TX board with previous versions of software tx v1.4_b003/b004/ISTest_b001,
which all give a reading for the wind vane, so I am wondering if there is a problem with the new software with regards to FO windvane.
User settings where as above in the TX attachment
I have been checking my TX board with local test mode and I am getting readings. but with the new software tx v1.5 I am not getting a reading off the windvane, which is fine offset type.
so I then checked the TX board with previous versions of software tx v1.4_b003/b004/ISTest_b001,
which all give a reading for the wind vane, so I am wondering if there is a problem with the new software with regards to FO windvane.
User settings where as above in the TX attachment