24-06-2015, 14:07
Thanks for the reply Uncle Bob, I have had a good read of the forum this morning and it may be slightly above my skills.
I am new to Arduino and so I might spend some time getting used to whats what, I have good (ish) soldering skills and have a decen soldering iron with digital control and I previously worked repairing medical and industrial endoscopes.
However after knee surgery I have been left in chronic pain and my pain meds render my brain useless a lot of the time and so I need extra time to figure it all out as there isn't a stage by stag, start to finish how to, but I will tackle it at some stage because this fine offset base station is not that good.
I am new to Arduino and so I might spend some time getting used to whats what, I have good (ish) soldering skills and have a decen soldering iron with digital control and I previously worked repairing medical and industrial endoscopes.
However after knee surgery I have been left in chronic pain and my pain meds render my brain useless a lot of the time and so I need extra time to figure it all out as there isn't a stage by stag, start to finish how to, but I will tackle it at some stage because this fine offset base station is not that good.