06-11-2024, 00:54
Hi Jochen,
I will try to anwser your BIG questions:
The answer is in the firmware download page:
WeatherDuino Air Quality Monitor III - v6.1_b010 - Release date: 2022-05-21
Tested with Arduino IDE 1.8.19 and ESP32 2.0.3 (may not compile with other versions).
No. Any good quality USB data cable will work.
OTA is for Over The Air programing. It only works after having programing your board by USB with WeatherDuino firmware.
For more info about how to use OTA, please search on Arduino foruns.
This optional transmiter module is for transmiting data in 433Mhz OOK. Its purpose is to make the AQMIII compatible with old (Pro2) WeatherDuino systems.
Hope had helped.
Kind regards
I will try to anwser your BIG questions:
Quote:What IDE version do I need?
The answer is in the firmware download page:
WeatherDuino Air Quality Monitor III - v6.1_b010 - Release date: 2022-05-21
Tested with Arduino IDE 1.8.19 and ESP32 2.0.3 (may not compile with other versions).
Quote:Do I need a special USB cable, other than the one I use for the ESP32 Boards?
No. Any good quality USB data cable will work.
Quote:How and is the OTA update working?
OTA is for Over The Air programing. It only works after having programing your board by USB with WeatherDuino firmware.
For more info about how to use OTA, please search on Arduino foruns.
Quote:On the picture, there is a PCB wit a second TX (RF96), what have I ordered, what is it for? (LORA?)
This optional transmiter module is for transmiting data in 433Mhz OOK. Its purpose is to make the AQMIII compatible with old (Pro2) WeatherDuino systems.
Hope had helped.
Kind regards