29-05-2024, 01:41
(17-05-2024, 22:55)Wx_man23 Wrote: No I don't think this is possible. Please see attached. I think I need an adapter to match the pins on the board? Thanks I am optimistic anyway.
Why you think it is not possible?
You are using the correct adapter and there isn't any other. You MUST cut one end of the red and black cable and use the correct wires to connect to the board.
The hornychz recommendation of using soldered screw terminals on the PCB makes things a lot easy, however as you already have pin headers on the PCB, you may try to solder the wires to the pin headers (after having double checking the connections are correct, use a continuity tester if needed).