22-05-2024, 23:18
Hi Wx_man23,
I would recommend you to use soldered screw terminals on the PCB, e.g. type KF128-2.54. It will be much easier for you to experiment with them and they can also serve well for a permanent connection (they are more reliable than just push-in pins).
It can then look like this - but be careful! The picture shows my old AQM, the connector for your PMS7003 is probably located elsewhere on your "new" board.
Good luck!
I would recommend you to use soldered screw terminals on the PCB, e.g. type KF128-2.54. It will be much easier for you to experiment with them and they can also serve well for a permanent connection (they are more reliable than just push-in pins).
It can then look like this - but be careful! The picture shows my old AQM, the connector for your PMS7003 is probably located elsewhere on your "new" board.
Good luck!