[werk_ag]

I do not question your words or your system!
I was simply going to study the ones (you know which ones) I use to see how the correction is done and done well,
I think I am able to analyse data according to t°/HUM drifts.
No big deal, I'll continue for my information.

Good evening

Hi Toby,
If the ones you have are using the sensor.community software, from what I think I know, their software also applies correction for humidity.


The problem is more notorious on homebuilt systems where people just buy the sensors, connect them to the microcontroller, use a library to read the data, and believe their data is right by just doing that.

Somewhere in the sensor.community forum there is a discussion about their concern on allowing the use of other sensors which may not be applying the required data corrections (they are aware that some are doing even more exotic things like adding heaters on the air intake, trying to keep %RH near 50%).
All this, simply could cause inconsistency between the sensors listed on their map. So their concern is quite reasonable.