20-06-2020, 22:11
For your complete peace of mind, I would like to start saying that if we conclude that Your Pro2 Compact receiver is damaged, I will repair it at no cost for you.
However, since all units are tested and programed before sent, and considering that its not easy create a damage on one unit, before send it back to me, I would like to ask you, to do some procedures:
1- On Config_Options.h enable the debug WiFi option, by uncommenting the first line. See below
then open the Arduino IDE serial monitor (set it to 19200 baud), compile the code and reprogram the device using the USB connection.
Copy and post here what you get on the Serial monitor
2- Can you please post here a screen copy of your Arduino IDE, after code compilation?
I'm asking for an image like the one below.
I may need more information, but for now the requested info will be enought.
Thank you.
Kind regards
However, since all units are tested and programed before sent, and considering that its not easy create a damage on one unit, before send it back to me, I would like to ask you, to do some procedures:
1- On Config_Options.h enable the debug WiFi option, by uncommenting the first line. See below
Code:
// --------------------------------------------------------------------------------------
// Debug helper - Print debug messages to serial monitor. For testing purposes ONLY.
//
// !!! NEVER LEAVE ANY OF THESE DEBUG FUNCTIONS ACTIVE WHEN THE STATION IS CONNECTED BY USB TO ANY WEATHER SOFTWARE !!!
// --------------------------------------------------------------------------------------
#define PRINT_DEBUG_WIFIthen open the Arduino IDE serial monitor (set it to 19200 baud), compile the code and reprogram the device using the USB connection.
Copy and post here what you get on the Serial monitor
2- Can you please post here a screen copy of your Arduino IDE, after code compilation?
I'm asking for an image like the one below.
I may need more information, but for now the requested info will be enought.
Thank you.
Kind regards