16-06-2020, 18:31
(16-06-2020, 18:25)bombenm Wrote:(15-06-2020, 21:01)Werk_AG Wrote: Hi,
You can try using the MultiSpeed_I2C_Scanner.ino utility (included in the software package) to check if the sensor is correctly detected on the I2C bus.
The BME280 should be at address 0x76
Rgs.
Hi,
I used the i2c scanner and i found the following adresses:
0x50
0x57 RTC module
0x68 RTC modale
0x77 BME280
Is there something wrong?
Thank you
Line 84 and line 90 of Config_option.h tab has been set to 0 for the BME280 sensor.