[bombenm]

Hello

I'm finally building my Pro2 plus and discover that I got 2 different BME280
1 with 7 pin ( BME280 adafruite) and one more simple with 6 pin !
On the pcb it's only 4 pin... 3.3 v, gnd, scl, sda

How to proceed ?

regards
jk

Hi jk,

If the sensor you have works in I2C mode, just connect those four pins on the pcb to the corresponding pins on the BME280 sensor module.
SCL, SDA are the standard designation for I2C communication lines. If your sensor module doesn't have those designations, try to ask manufacturer if it works in I2C mode, and what pins to use.

I quick search on the Adafruit BME280 datasheet will show you what pins to use: https://learn.adafruit.com/assets/26693

Rgs

Hello , I engage in this discussion.

I finished building the weatherduino pro 2 receiver with the 4pro wireless display. I immediately noticed that I have problems with the bme280 sensor. When I receive the data from the tx, the 4pro wireless display shows the humidity and external temperature value while the rx does not transmit the data from the bme280. In this case the wireless display shows the temperature value = 0.0 while the atmospheric pressure = - 2147484 mb. I purchased the bme280 sensor from adafruit site and I am sure of the connections and settings made. Anyone have any suggestions to give me. Thank you. Regards.