24-01-2020, 23:55
(24-01-2020, 20:54)AllanG Wrote:(24-01-2020, 18:32)hornychz Wrote: Eureka! Printed without any problems. Things seem much easier with Czech software ...
...for me, things always seem much easier with Czech beer!!
That looks very good, Zdenek. I too have been using Cura since I got my printer last year. I have had some good results using it, but I have also had a lot of failures. I installed Prusa Slicer a week ago and have started to learn how to use it, but I have not yet printed anything with it. I think I will try the front plate for the Pro2+ case again. I have a good one using Cura but have always thought the logo could be better. I will now try with Prusa and find out!
Yes, Allan, you are right!Ultimaker Cura is good, because you can slice and print too with it. When you use PrusaSlicer, it can't print, you have to use another software.
I installed the Repetier-Host v2.1.6 (not Repetier-Server -> it is enabled by default!) the first. It has PrusaSlicer inside, but old version,
so after this I has installed PrusaSlicer v2.2.0-alpha2. And at the end is needed to configure Repetier-Host "directory with config files of Creality Ender-3",
in my case they are in C:\Users\hornychz\AppData\Roaming\PrusaSlicer-alpha (it is a hidden directory).
I must say that PrusaSlicer has much more better preview then Cura and Repetier-Host can display printing process, Cura doesn't it...