[werk_ag]

Can you activate the Auriol debug messages as the bottom of the config options and see what the serial monitor of arduino is showing?

regards,
engolling

I've tried your recommendation, I think the result is not really enlightening.

Hi,

WeatherDuino outputs debug messages to the serial monitor at 19200 baud. Please try open the serial monitor at 19200 baud instead of 115200.

Hi Sun_Dancer,

Please download latest WeatherDuino Pro2 Compact (v3.2_b002) software and install it. It fixes some bugs related to Auriol and compatible weather stations and greatly improves reception.
When possible please report back if it fixed the reported issues.

Keep in mind that the Auriol weather stations send some data packets at intervals which can be great than 2 minutes (temperature is one of them).

Hello Werk_AG, thanks for the update. Unfortunately, it has not corrected the mistakes for me. The problems with the temperature and humidity values still exist. I ordered an outdoor sensor from Ventus (W044). This should probably work with the Auriol weather station. I hope that he works with the Pro2 Compact and, yes, then I'm curious how the values will turn out.
In any case, the speed of the connection has improved.
greetings

Temporarily I have reactivated my old Auriol weather station in an attempt to reproduce the reported behaviour, up to now I haven't see any problem with the temperature readings, both systems update almost at the same time, however I will continue monitoring the system to see if something wrong comes out.

   

   


Weatherduino only receives Temp / Hum data from channel 1, which is the default channel for the embedded T/H sensor on the Auriol transmitter unit, so most probably it will not get data from any other outdoor sensor. If you have any other indoor or outdoor 433MHz RF sensors, try temporarily disable them to check if this could be the cause of the corrupted T/H data.