[qldbureau]

Ok my Rx unit has been sitting on a table for the last couple hours on a table to test things out. I fine tuned the offset values for temperature and atmospheric pressures in the code and readings are consistent. Atmospheric pressure is within a couple of points to my local station, and pressure changes correspond in the same direction during my test time.

Cumulus is even talking to it and set the Real Time Clock for me.

   

Confession time: My setback I mentioned earlier is that I accidentally shorted my crude temporary temperature sensor leads. Unfortunately my other Nano board let smoke out and did not survive. So pleased I decided to install sockets for the Nano. Now the Nano intended for the TX board is running the RX, and I have ordered replacements. Probably take a week judging by my original order.

Then on the second Nano, the display booted to the welcome screen and then blank, I worried I had done more damage. Especially when I tested the 5v pins with my multimeter and found them running at 3.4 - 4 volts. Evidently that does not seem to worry anything as all is running well since I altered the display refresh line for testing as Werk advised. Thanks again!

Over all this is great!