14-02-2015, 12:44
Commenced my building today, with the RX board. I did really well with sockets for the Nano. Everything is pretty much on board the RX except for the receiver and transmitter modules which have not arrived yet. I also have not connected the internal temperature and humidity due to not making up its cable yet.
I have tried an upload of the RX software with my 20x4 LCD configured. It runs through the boot and welcome screen! However it ends there at a blank screen. Although I only have the barometric sensor connected, should I at least end up with readings for that, and 0 for the rest. Or is it reliant on all sensors being present, and TX signal being received to continue scrolling?
Next stage build TX board, and await arrival of RX board's receiver and relay transmitter.
I have tried an upload of the RX software with my 20x4 LCD configured. It runs through the boot and welcome screen! However it ends there at a blank screen. Although I only have the barometric sensor connected, should I at least end up with readings for that, and 0 for the rest. Or is it reliant on all sensors being present, and TX signal being received to continue scrolling?
Next stage build TX board, and await arrival of RX board's receiver and relay transmitter.