05-09-2018, 00:40
(04-09-2018, 11:56)mikeyk Wrote: My boards arrived today, a TX and a RX Pro 2Plus !!!
I haven't received all my other bits yet. But I did receive my Mega 2560 and Nano.
But I didn't pay enough attention to the Mega2560 I purchased, I bought one with slightly different pin arrangement. It is slightly wider. I was trying to save postage by getting the Nano and Meduino Mega2560 R3 from the same supplier.
Oh well.. I've now ordered the correct board.
Hi,
Don't forget to carefully read this post: https://meteocercal.info/forum/Thread-We...49#pid6249
Do your best to resist to the temptation to "test" an unfinished board. Only apply power to the RX board after having everything needed connected to it: TFT, T/H sensor, ATM sensor, Program /RUN switch, etc. Attempts to "test" unfinished RX boards are the most frequent cause of damages.
Always start by building the TX unit first.