02-01-2023, 06:56
(31-12-2022, 01:35)Werk_AG Wrote:Ok - i tried inspecting the unit and could not see any sign of water ingress or insect debris.
I then disconnected the power and removed the Nano and inspected it. Could not see any issues. I then reconnected it and disconnected it about 5 times and it did not make any difference. When I pressed the reset button on the nano the "l" LED next to the power LED on the nano flashed briefly.
I then reflashed the nano and it did not seem to make any difference.
I then replaced it with a new nano and that did not seem to make a difference.
I then checked the voltages on the TX board. The 3.3, 5 and 9V connection points all had the correct voltage. The Battery voltage was 14.4 volts, it was a bright sunny day.
I placed the multimeter on the TX LED and the voltage was pulsing even though i could not see the LED flashing. Not sure if the LED is working ? or if its just nor visible in bright daylight
None of this seemed to help as the receiver is still not getting any data.
Open to suggestions on where to go next ?