12-03-2019, 09:48
Good news, the WD is now receiving data fine, I had missed this line in the config options on the Pro2 plus RX boards code.
it was set to 0! but now its on2 it works fine, I have yet to get the Pro2 RX to send the data, but that can wait for a while whilst I get everything else setup.
I could not find any TX modules so bought some from RF solutions that just need the pinout changing, I'd post a photo but couldn't easily figure out how!.
Many thnaks for all your help with this..Andy
Code:
#define BROADCAST_DATA 1 // 0= Disables Data Broadcast, 1= Broadcast by WiFi, 2= Broadcast by RFit was set to 0! but now its on2 it works fine, I have yet to get the Pro2 RX to send the data, but that can wait for a while whilst I get everything else setup.
I could not find any TX modules so bought some from RF solutions that just need the pinout changing, I'd post a photo but couldn't easily figure out how!.
Many thnaks for all your help with this..Andy