[Wizza]

Hi Werk,

I went to reflash one of my older wireless displays.  It has a 2.8" TFT screen, mounted in behind a transparent LID (photos on my old build thread).  The screen is not accessable for "touch" operation.  I have a push button mounted on the top of the enclosure.




I was compiling with the following ver code:

Version:               : WD PLUS 1.0-b005 (Requires Arduino IDE 1.7.7 or newer to compile)
 Version Release date   : 11/01/2017
 Last revision date     : 11/01/2017



In user options, I set the following:

// --- Define your Display type
#define DisplayType           1    // 1= TFT 320x240 ILI9341, 4= 20x4 LCD, 5= 16x2 LCD
// --- Define if your ILI9341 Display have touch capabilities - ATENTION! Requires WD board v2.20 or greater 
#define Touch_Display         0    // 0= Display without touch panel, 1 = Display with touch panel
// --- Define Backlight timeOut
byte BackLight_Timeout    =   0;   // Timeout for TFT backlight in minutes (1 to 255). 0= Always ON
#define Board_Type            1    // 1= Wireless Display Boards >= 2.xx, 0= Others (Old RX converted boards)


When I compile I get the following error:

WeatherDuino_Pro2Plus_WD_v1.0_b005.ino: In function 'void setup()':
WeatherDuino_Pro2Plus_WD_v1.0_b005.ino:238:11: error: 'T_DIN' was not declared in this scope
WeatherDuino_Pro2Plus_WD_v1.0_b005.ino:239:11: error: 'T_IRQ' was not declared in this scope
Error compiling.


If I change screen Touch_Display to value "1=Display with touch panel", then I get NO errors and can load the nano ok without error.  But then the push button on top of enclosure is not operational.

Would you be able to have a look at this one sometime, and give me some comment...

Thanks Werk...

Mark R