This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RTC module - Assembly hints
Some hints to assemble the RTC module in a v3.0x RX board and get a perfect fit.

Take a 4 pin right angle connector.

[Image: RTC_assembly_01.jpg]

Insert it, with the long pins in the RTC module as show in picture below.
Solder and cut pins in excess.

[Image: RTC_assembly_02.jpg]

Insert the RTC module in the RX board as show in picture below.
Only solder the RTC module after all other parts are assembled.

[Image: RTC_assembly_03.jpg]
MeteoCercal - Air Quality Data
Click here to watch at my ThingSpeak channel


Users browsing this thread: 1 Guest(s)